Posts: 43
From:Los angeles,CA,USA
Registered: Jan 2001

posted 01-28-2001 09:14 PM            

---

Im trying to open a door with the pulley but everytime I try it doesent work. I set the trigger to switch and I use the furniture 0 with it but it doesent open the door and also the chain just keeps on moving down into the floor. What am I doing wrong?

IP: Logged

Posts: 538
From:LONDON, ENGLAND
Registered: Jan 2001

posted 01-29-2001 12:44 AM               

---

This might sound obvious, but you have set the door to the same trigger square as the one with the switch on it?

Col

------------------
www.tombraider-customlevels.fsnet.co.uk

IP: Logged

Posts: 43
From:Los angeles,CA,USA
Registered: Jan 2001

posted 01-30-2001 11:22 PM            

---

yeah I did that but like I said the chain keeps moving after I have pulled it and it doesent activate the trigger for the door.

IP: Logged

Posts: 538
From:LONDON, ENGLAND
Registered: Jan 2001

posted 01-31-2001 07:26 AM               

---

Try not setting the trigger as switch.

Just place the two pieces on the same square then set the trigger for the door to that square.

Col

------------------
www.tombraider-customlevels.fsnet.co.uk

IP: Logged

Posts: 43
From:Los angeles,CA,USA
Registered: Jan 2001

posted 02-01-2001 11:22 AM            

---

That would work but then again I wouldnt need the pulley at all if the door could be opened by simply steping on a square. Is there a sample wad where the pulley is used so that I can get an idea?

IP: Logged

Posts: 92
From:The Netherlands
Registered: May 99

posted 02-01-2001 11:53 AM               

---

Try the Settomb wad, somewhere near the torches puzzle to get the sands of time...

IP: Logged

Posts: 43
From:Los angeles,CA,USA
Registered: Jan 2001

posted 02-01-2001 01:25 PM            

---

Ok I checked the settomb wad and the trigger type for the pulley is set to switch so I guess i'll try it again but I know I done this before. If it doesent work I will post again.

IP: Logged

Posts: 102
From:Phoenix, Arizona, USA
Registered: Dec 2000

posted 02-01-2001 01:48 PM               

---

Here's how I got this to work.

Set the trigger for the pulley to switch type and turn on One Shot. Also enter 1 in the OCB window for the pulley.

IP: Logged

Posts: 43
From:Los angeles,CA,USA
Registered: Jan 2001

posted 02-01-2001 02:33 PM            

---

Thanks Hagar it worked 100%....You are def a tomb raider and a reliable source. But it says nothing about this code bit 1 stuff in the manual per page 87,,,check it out. And thanks again....like a million. Would you happen to know how to split a flyby cam sequence into 4 switches? Everytime I try to do it the cam starts after the first switch is pulled.....help if you can.

IP: Logged